EisSound 400 Series Manual de Instalação descarregar pdf (Página 39)

Key Sequence Display Visual

The default function for the +/- keys when the Control Unit is on is to adjust the volume. A

few seconds after the last key entry the Control Unit will return to its default function of volume

adjustment.

Pressing the key sequentially switches between the bass, treble,

loudness and balance mode adjustments. The +/- keys can be used to

adjust the level of each parameter that is activated at that time.

vol 55

BAS +24

TRE +17

loud 0

BAS +12

TRE +11

loud 1

def

To limit the channels flipped through to the channels installed, this information must be previously set up in the Master Unit

installation (see 3.1.4.A. Number Of Audio Channels Installed). This information can be supplemented by assigning a personalized

channel number to each Control Unit to limit or extend channel access to certain zones of the system. (See 4.1.6 , 4.1.8)

4.1.2.C. Audio Level Adjustment

To access a channel directly, press the channel number

followed by the CH key. For example, to select channel 3.

To flip through the different channels, enter channel selection

mode by pressing the CH key.

In this mode the function of the +,- keys is channel selection.

The channels scrolled through are the channels set up in each

Control Unit only.

CC-1023ENG-10

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 99 100

Sem comentários

EisSound 400 Series Manual de Instalação Página 39